Glow worm energysaver registration#
Glow worm energysaver plus#

less than 0.7bar, the appliance will shut down showing flashing: ‘1’ then ‘2 * ’ on the display. NOTE: If the pressure gauge indicates a loss of system pressure, i.e. Contact your installation / servicing company if the fault persists.ĬAUTION: This boiler works in a pressurised system which must only be drained, refilled and pressurised by a competent person. Press the reset button to restart the boiler. Release an ice blockage by the use of warm cloths on the pipe. During freezing conditions this may be due to the forming of ice in the condense drain external to the house. The display will repeatedly flash ‘ 0’ then ‘8 * ’. If in doubt, contact you installation/servicing company for advice.Īs a safety feature the boiler will stop working if the condensate drain becomes blocked. If the mains electricity and gas are to be turned off for any long periods during severe weather, it is recommended that the whole system, including the combination boiler, should be drained to avoid the risk of freezing. Any other exposed areas of the system should be protected. The boiler has a built in frost protection programme as long as the electricity and gas are left switched on.

If the boiler is fitted into a compartment or cupboard do not use the compartment or cupboard for storage. You can check your installer is CORGI registered by calling CORGI direct on :- 01256 372300. Both should be recorded in your boiler Logbook.

Glow worm energysaver registration#

Please be advised that the ‘Benchmark’ logbook should be completed by the installation engineer on completion of commissioning and servicing.Īll CORGI Registered Installers carry a CORGI ID card, and have a registration number. To obtain service, please call your installer or Heatcall (Glowworm’s own service organisation) using the telephone number on the back cover of this booklet. Servicing/maintenance should be carried out by a competent person in accordance with the rules in force in the countries of destination. If this appliance is installed in a rented property there is a duty of care imposed on the owner of the property by the current issue of the Gas Safety (Installation and Use) Regulations, Section 35. To turn it on again follow the instructions given in ‘To Operate the Boiler’. To turn off the boiler for servicing, isolate it from the electrical supply. To turn off the domestic hot water select To turn off the central heating use the room thermostat or clock/ timer. It is preferable to leave the electrical supply on whenever possible to permit operation of the built-in frost protection (see ‘Protection Against Freezing’) and daily pump and valve exercise. Repeated pressing of the ‘Mode’ button will eventually return the display to show boiler temperature, see diagram 11.4. These cover fault indication and servicing and should only be accessed by the service engineer. Other modes are available by repeatedly pressing the ‘Mode’ button. Temperature Selection and Control Options are detailed in sections 11.8 to 11.11. The operation of the boiler can be altered by using the ‘Mode’ button. It is factory preset to supply domestic hot water up to 65 oC and central heating up to 70 oC. If the display is flashing, press the 'reset' button, shown on diagram 1.Ĩ. Set clock/timer (if fitted) and any remote controls as required.ħ.

Glow worm energysaver plus#

Our Guarantee gives you peace of mind plus valuable protection against breakdown by covering the cost of: If this card is missing you can obtain a copy or record your registration by telephoning the Heatcall Customer Service number 01773 828100. In the centre pages are to be found your Guarantee Registration Card, which we recommend you complete and return as soon as possible. Glow-worm appliances' are manufactured to the very highest standard so we are pleased to offer our customers' a Comprehensive First Year Guarantee. Thank you for installing a new Glow-worm appliance in your home.

The instructions are an integral part of the appliance and must, to comply with the current issue of the Gas Safety (Installation and Use) Regulations, be handed to the user on completion of the installation. The instructions consist of three parts, User, Installation and Servicing Instructions, which includes the Guarantee Registration Card. Regulations/Requirements apply only to the United Kingdom.įor Ireland the rules in force must be used. Reference in these instructions to British Standards and Statutory